Ioline CrystalPress Quick Start Manual page 9

Prepare the CrystalPress to Print
Required Materials: It is time to load
the CrystalPress with consumables
before starting up the first time.
Make sure you have Transfer Sheets
and crystals available for these steps.
Pinch Wheel Lever
Locate the Pinch Wheel Lever on the back of the
1
CrystalPress then rotate the lever back until it
stops. This will lift the Pinch Wheels.
Peel the backing off a Transfer Sheet to expose
2
the sticky side.
Right Pinch Wheel
Slide a Transfer Sheet into the machine as shown.
3
Make sure the sticky side is facing up and that
the right and left wheels are aligned with the Pa-
per Strips on each side of the Transfer Sheet. Make
the sheet as straight as possible before lowering
the wheels with the Pinchwheel Lever.
New motif starts
above here...
4
5
Paper Strip
9
Front edge of Transfer Sheet
The White Pounce Strip shows where printing
begins. Pull or push the Transfer Sheet so that
at least 1/4 inch of the edge is past the White
Pounce Strip to ensure smooth operation.
Note: Make sure that the stones for the first Motif
match the size of the Sorter Wheel(s) installed in
the Sorter Bowl.
Slowly pour stones into the lower portion of
the right side Sorter Bowl. At least one gross of
stones is required for most sizes. Repeat in the
left Sorter Bowl if printing from both bowls.
IMPORTANT: DO NOT OVERFILL THE BOWL (see
table in the Cautions and Tips section below). The
stones should not pile higher than the crease in-
side the bowl casing as shown above. Too many
stones in the Sorter Bowl cause upsidedown
placements.
1 gross = 144 stones
White Pounce Strip