Ioline CrystalPress Quick Start Manual page 10

Powering up the CrystalPress
Note: The CrystalPress will always go through
the initialization process described below when
the power is turned on.
Power Switch*
Power Cable
* ON/OFF symbol (O/I) locations may vary
1
Plug in the power and USB cables to the back of
the CrystalPress. The square (B) connector on
the USB cable attaches to the CrystalPress.
2
Plug in the USB cable to a USB port on the
computer where the CrystalStudio software was
installed. The flat (A) connector on the USB cable
connects to the PC.
Turn on power to the machine. The Carriage will
3
move to the right and hit the right end.
Note: A message should appear on the computer
that New Hardware is Found and that Windows is
searching for drivers. Make sure that the hardware
is installed successfully before sending a motif.
Directions on making Motifs and troubleshooting tips for using the CrystalPress are cov-
ered in the electronic CrystalPress User Guide included on the CDROM and copied to the
hard disk during installation. The CrystalStudio User Guide will help with using the software.
USB Cable
Then the Carriage will move left until it hits the
4
left end plate.
The Carriage will move to the right until it stops
5
at the right end. Then the Sorter Wheels will turn
and stop. Once the green light appears on the
keypad the CrystalPress is ready to print.
Note: There are a number of solid red lights on
the CrystalPress on the Carriage and the Sorter
Bowls. These are normal and required for the ma-
chine to operate. Blinking lights indicate an error.
DON'T STOP NOW!
The Motif making process is reviewed in the Crys-
talPress User Guide. Follow those instructions and
learn to use the CrystalStudio software with the
CrystalStudio User Guide. These will help you make
the first motifs with your CrystalPress.
10