Ioline CrystalPress Quick Start Manual page 8

Assemble and Install the C-Stick
HINT: It usually helps to move the carriage all the way to the left end plate when installing
the C-Stick so that it does not roll along the traverse while tightening the Cable Clamp Nut
and Thumbscrew . Make sure power is off before moving the carriage by hand.
C-Stick Body
C-Stick Tip
Remove a C-Stick Tip and the C-Stick Body from
1
the protective bags. Install the tip on the body
by rotating counter clockwise as shown.
Note: Do not overtighten the tip as it will make
later removal difficult.
Clamp
Thumbscrew
Loosen the Carriage Thumbscrew by turning it
2
counter-clockwise until the Clamp can swing
down over the C-Stick after insertion.
Note: Make sure the Clamp is in the up position
before inserting the C-Stick.
Insert the C-Stick into the Carriage Jaw as shown.
3
The C-Stick has a ring flange around the middle
that fits into a slot in the Carriage Jaw.
Clamp
Rotate the Clamp down clockwise and tighten
4
the Thumbscrew until the C-Stick is snug. Do not
overtighten.
Insert
Cable
Push the black C-Stick cable into the socket at
5
Jaw
the top left corner of the Carriage cover. Route
behind the pump first on CP-II (pump hidden).
Note: Make sure the Socket Nut is loose then push
the cable all the way in until it stops. Lightly tighten
the nut after insertion. Don't overtighten.
C-Stick
(CP-II shown)
CP-II Only: Press the loose end of the vacuum
6
hose fully onto the tool body barb until it stops.
Note: Use firm pressure to ensure the tube is
seated all the way onto the barb.
8
Thumbscrew
Socket Nut