Ioline CrystalPress Quick Start Manual page 11

Removing Crystals from
the Sorter Bowl
Removing stones from the sorter is also
very easy. Simply remove the wheel
from the Sorter Bowl. Hold a container
under the bowl and press down on the
Stone Release Door. The Rhinestones
will drop out of the bowl through a hole
and into the container.
Cautions & Tips
Loading Crystals in the Sorter Bowl
Loading the Sorter Bowl assembly on the CrystalPress is very easy. In or-
der for the Sorter Wheel to pick up stones properly the Sorter Bowl must be
filled with enough stones. Use the table below to gauge the approximate
amount of stones to use for each size.
Min. Gross
Size
Required
6ss
6
10ss 1
12ss
1
16ss
1
20ss 0.5
30ss
0.5
Stone Release Door
The Pick and Place tool requires careful treatment to en-
sure the longest possible life.
If the CrystalPress will not pick up a stone or drops stones
while it's moving, the C-Stick may be damaged. See below
to clean the tool tip to determine if it is dirty. If there are
missing 'chunks' out of the tip, replace the C-Stick tip.
Cleaning the C-Stick (CP-I Only)
• A detailed cleaning procedure for the C-Stick is included
• A quick way to lightly restore the C-Stick is to touch the
11
CAUTION: DO NOT OVERFILL!
Max. Gross
The stones should not pile higher
Allowed
than the crease inside the bowl
35
casing as shown at left. Too many
22
stones in the Sorter Bowl cause
upsidedown
18
the table at left for the maximum
9
amount of stones to load by size.
6
1
Press
Down
The C-Stick or Pick and Place Tool
in the CrystalPress User Guide in the Routine Maintenance
chapter.
tip of the tool to the adhesive part of the Transfer Sheet
a few times.
placements.
1 gross = 144 stones
See