Operation And Functions; Startup - Mitsubishi Electric MELSERVO-J3W Series Instruction Manual

13. USING A LINEAR SERVO MOTOR

13.5 Operation and functions

13.5.1 Startup

(1) Startup procedure
Start up the linear servo referring to the following procedure.
POINT
To use a linear servo motor, turn SW3 on.
Setting of the servo motor selection switch (SW3) (Refer to section 3.14.)
Set the linear servo motor series and linear servo motor type.
(Refer to (2) of this section.)
(Note) Settings of the linear encoder direction and the linear servo motor
direction (Refer to (3) in this section.)
Incremental linear encoder
(Note) Setting of the linear encoder resolution (Refer to (4) in this section.)
(Note) Execution of the magnetic pole detection (Refer to section
13.5.2 (3).)
(Note) Positioning operation check (Refer to section 13.5.4.)
Positioning operation check using the controller (Refer to section 13.5.5.)
Home position return (Refer to section 13.5.3.)
Note. MR Configurator is used.
SW3
ON
A-axis
B-axis
Execution of installation and wiring
What is the type
of linear encoder?
Change to the setting not requiring the magnetic
pole detection (Refer to section 13.5.2 (3).)
Positioning operation
13 - 14
Absolute position linear encoder