SATO M-84PRO Operator's Manual page 54

Section 3. Configuration
USER DOWNLOAD
WAITING
HEX DUMP MODE
In addition to the Test Print Labels, the printer can print the contents of the receive buffer in a
hexadecimal format to allow the data stream to be examined for errors and troubleshooting.
V 05.00.03.00
INITIALIZING
ONLINE
Page 3-28
2. Press the LINE key. The printer is now waiting for the data to
be sent.
3. Transmit the download data command stream to the printer.
4. After the data has been received, the printer will beep and
print a status label. If it does not beep and print a status
label, the printer did not accept the data.
5. If the printer did not beep and print a status label, turn the
printer off and check your data stream for errors and start
the download process over.
6. If the custom codes are correct, press the FEED key to
accept them and terminate the download process. If they
are incorrect, turn the printer off without pressing the
ENTER key and begin the process again.
Displays the firmware during the initialization.
The Hex Dump Mode is entered by placing DSW2-4 in the on
QTY:000000 position and powering the printer on.
1. The printer is now ready to receive data.
2. Send the data stream to the printer.
3. The received data will be printed in a hexadecimal format4.
To return the printer to normal operation, place DSW2-4 in
the off position and power the printer off and then back on.
PN 9001105 Rev. A SATO M-84PRO