Plug-In Interface Modules - SATO M-84PRO Operator's Manual

Section 7. Optional Accessories
ERROR DESCRIPTION
Low Battery - Low battery
condition is detected
when printer is powered
on.
Card R/W Error
1 No card is inserted.
2 Card is write protected.
3 Invalid store/recall
number.
4 Card has not been
initialized.
Warning
1 Duplicate number.
2 Data not in print area.
3 Data overflows card
memory.

PLUG-IN INTERFACE MODULES

The Series "e" and PRO printers have user changable Plug-In Interface Modules. The Interface Module is
accessible from the Rear Panel and is retained by two screws. Use the following procedure to replace an
interface molule.
1. Turn power off both the printer and the host and remove the power and interface cables.
WARNING: Never connect or disconnect interface cables (or use a switch box) with power
applied to either the host or the printer. This may cause damage to the interface
circuitry and is not covered by warranty.
2. Remove the two Interface Module Retaining Screws.
3. Grasp the Interface Module and pull it out of the connector.
4. Place the new Interface Module in the slot and press inward firmly until it is properly seated.
5. Replace the two Interface Card Retaining Screws.
6. If the new Interface Module is for a serial interface, set DSW1 for the proper operation.
7. Connect the interface cable to the connector
Page 7-2
INDICATION
ERROR LED: Blinking
Audible Beep: 1 long
Display: Card Low
Battery
ERROR LED: On
Audible Beep: 1 long
Display: Card R/W Error
Printer must be powered off to
reset.
Audible Beep: 1 short
Display: None
Printer will ignore invalid
commands.
PN 9001105 Rev. A
REMEDY
Depress LINE key to print
Card Status.
Replace Memory Card
battery. Note that all data
will be lost when the
battery is removed.
1 Insert card into selected
slot.
2 Remove write protect
tab.
3 Correct program
4 Initialize card with BJF
command.
1 Correct program.
2 Correct program.
3 Use card with more
capacity.
SATO M-84PRO