Data Dump Diagnostic Label - SATO D508 Operator's Manual

3.7 DATA DUMP DIAGNOSTIC LABEL

The contents of the printer buffer can be examined using the DATA Dump mode. This printout
labels each line of the received data in the left hand column, the data in the middle column
followed by the same data in ASCII format in the right-hand column.
1. Turn the printer OFF.
2. Place DSW7 on the configuration Switch in the ON position.
3. Turn the printer ON.
4. Transmit data to the printer.
5. The data received is printed on the label.
6. Place DSW7 in the OFF position.
7. Turn the printer OFF and then back ON to place it back in the normal print mode.
Note:
Depending on the version of your printer's onboard software, the appearance of your test
printout may be different from that shown here.
SATO D508/D512 Operator Manual
Section 3: Configuration and Operation
Page 3-11