Error Codes - SATO D508 Operator's Manual

3.4 ERROR CODES

The ERROR display is a seven-segment LED array that provides information on error conditions
detected by the printer. The conditions are:
0
1
2
3
4
5
6
7
8
8. ON
A ON
b ON
c ON
d ON
E ON
F
For more information on the cause and troubleshooting of printer errors, see Section 6.
Troubleshooting.
SATO D508/D512 Operator Manual
ON 1 Beep
ON 1 Beep
ON 1 Beep
ON 1 Beep
Blink 3 Beeps
Blink 3 Beeps
Blink 3 Beeps
Blink 3 Beeps
ON
1 Beep
1 Beep
1 Beep
1 Beep
1 Beep
3 Beeps
Section 3: Configuration and Operation
Flash Memory error Consult your SATO dealer
Not Assigned
Machine Error
EEPROM Error
Electrical Head error Replace Print Head or consult
your SATO dealer
Head Not Latched
make sure the Top Cover is
closed properly
Out of Paper
2) Route paper through sensor
Sensor error
Cutter error Connect cutter (optional item)
properly or consult your SATO
dealer
Program Error
Receive Buffer Over- 1) Restart the printer and retry
flow
2) Modify host SW
3) Select correct communication
Parity error Correct the Parity Settings or
(Serial I/F only) consult your SATO dealer
Framing Error Check and correct the data bit
(Serial I/F only) setting and retry
Overrun Error Check and correct the flow con-
(Serial I/F only) trol settings and retry
LAN Time Out Error
associated connections to/from
it. Replace if necessary
Font/graphic Data Recheck and correct the data
Error (Serial I/F only) stream and retry
Consult your SATO dealer
Replace EEPROM
Latch Print Head securely and
1) Replenish paper supply
correctly
1) Adjust sensor level
Resend data to the printer
protocol settings
Check the Interface Card and all
Page 3-7