Wireless Lan Interface (802.11 B/G) - SATO D508 Operator's Manual

SECTION 5: INTERFACE SPECIFICATIONS

5.7 WIRELESS LAN INTERFACE (802.11 B/G)

The wireless print server provides easy printer interface with 802.11G Wi-Fi compliant networks
free of wired connections. Each printer is shipped with an integrated driver and interface
installed. The driver must be loaded onto the host computer and configured to run one of the
supported protocols.
SPECIFICATIONS
Variable Data Rates
Frequency Band
Wired Equivalent Privacy
Sensitivity
Range
Protocols
Protocol
IP Address
Subnet Mask
Gateway Address
Communication Mode
SSID
Channels
DIP SWITCH SETTINGS
The DIP switches serve to initialize the configuration saved on the Wireless-LAN board, print
the configuration, and make a self-diagnosis. To communicate with the host,set the communi-
cation mode by through switches 5 and 6, then set the remaining switches to the OFF position.
Print of configuration and self-diagnosis are operable only on the screen after turning on the
printer. Ensure all switches are in the OFF position when operating the printer.
SWITCH
1
2
3
4
NOTE: The communication mode may be set within the printer's Interface Mode. Go to [Com-
munication] of the Interface Mode to enable setup by either the DIP switches or through the
Interface Mode.
Page 5-8
54, 11, 5.5, 2 and 1 Mbps
2.4 GHz ISM Band
128 bit, 64 bit (compatible with 40bit), WPA, none
(typ, AAWGN, 8E-2 PER): -91dBm at 1Mbps, -88dBm at 2
Mdps, -87dBm at 5.5Mbps, 84dBm at 11Mbps.
100m indoors, 300m outdoors
TCP/IP, IPX/SPX, Direct Mode IPX/IP, DLC/LLC, NetBEUI,
NetBIOS/IP
Status3 return
Protocol for Driver (cyclic response mode)
Protocol for Driver (ENQ response mode)
Status5 return
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
802.11 Ad hoc, Ad hoc, Infrastructure
Optional alphanumeric character string (up to 32 characters)
01 to 11
SETTING
Reserved for test use only (setup prohibited).
LAN board EEPROM initialization (initialize configura-
tion).
Print configuration details on a label (diagnostic & config-
uration).
Print a self-diagmosis of the board onto a label (wireless
mode).
SATO D508/D512 Operator Manual