SATO CL408-412e Supplemental Operating Manual page 39

FUNCTION
Data Bit
Parity
Stop Bit
Baud Rate
Protocol
2-1 2-2
OFF OFF
DSW1 FUNCTION
2-1 Reserved
2-2 Media Sensor Selection
2-3 Head Check
2-4 Hex Dump
2-5 Multi-Job Receive Buffer
2-6 Firmware Download
2-7 Protocol Code
2-8 Operational Mode
FUNCTION
Media Sensor Selection
Head Check
Hex Dump
Multi-Job Receive Buffer
Firmware Download
Protocol Code
Operational Mode
CL408-412e Supplemental Manual
Unit 4: Printer Configuration
DSW1 FUNCTION DESCRIPTIONS
Sets the printer to receive either 7 or 8 bits of data for each byte transmitted.
Selects the type of parity used for error detection.
Selects the number of stop bits to end each byte transmission.
Select the data rate (bps) for the RS232 port.
Selects the flow control and status reporting protocols.
DSW2 DEFAULT SETTINGS
2-3 2-4
OFF OFF
DSW2 CONFIGURATION
SETTING
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
DSW2 FUNCTION DESCRIPTIONS
Selects between a Gap or Eye-Mark detector.
When enabled, will check for malfunctioning head elements.
Allows hexadecimal printing of all data received to the print buffer.
Allows to continuously receive print jobs while compiling and printing other jobs.
Places printer in mode for downloading software into flash ROM.
Selects the command codes used for protocol control.
Normal mode or for original M8400.
4-4
DESCRIPTION
2-5 2-6
OFF OFF
CONFIGURATION
Gap Sensor
Eye-Mark Sensor
Head Check Disabled
Head Check Enabled
Hex Dump Disabled.
Hex Dump Enabled
Single Job Receive Buffer
Multi-Job Receive Buffer
Disabled
Enabled
Standard Protocol Mode
Non-Standard Protocol Mode
Normal Operation
Emulation Mode for Original M8400
DESCRIPTION
2-7 2-8
OFF OFF
PN: 9001159A