Dipswitch Settings - SATO CL408-412e Supplemental Operating Manual

DIPSWITCH SETTINGS

This chapter identifies the functions of the printer's integrated dipswitches. The dipswitch complex is located on the
printer's operator panel and is an integral part of its configuration by enabling/disabling various operational
features. Refer to the table below on switch designation and their specific functions.
ATTENTION: Each dipswitch must be set for the printer to properly function. Address
all eight switches individually, but some may not require change.
NOTE: A small, flat tool similar to a screwdriver is required to alter dipswitch position.
When changing a switch setting, ensure that it has been moved fully up or down.
NOTE: The switches are arranged horizontally, from left to right, and oriented
vertically. The ON position is always upward and the OFF position is always
downward.
1-1 1-2
OFF OFF
1-1 Data BIt
1-2
Parity
1-3
1-4 Stop Bit
1-5
Baud Rate
1-6
1-7
Protocol
1-8
CL408-412e Supplemental Manual
Unit 4: Printer Configuration
DSW1 DEFAULT SETTINGS
1-3 1-4
OFF OFF
DSW1 CONFIGURATION
OFF
ON
1-2 1-3
ON ON
ON OFF
OFF ON
OFF OFF
OFF
ON
1-5 1-6
ON ON
ON OFF
OFF ON
OFF OFF
1-7 1-8
ON ON
ON OFF
OFF ON
OFF OFF
4-3
1-5 1-6
OFF OFF
8 Data Bit
7 Data Bit
Reserved
Odd
Even
None
1 Stop Bit
2 Stop Bit
Normal: 2400, High Speed: 57600
Normal: 4800, High Speed: 38400
Normal: 19200, High Speed: 19200
Normal: 9600, High Speed: 9600
Status 4
Status 3
XOn / XOff
Ready / Busy
1-7 1-8
OFF OFF
PN: 9001159A