Setup Menu - Epson SC-B7000 Series Service Manual

SC-F7000 Serie/SC-B7000 Series

1.5.1 Setup Menu

Menu
Remaining Setup
Media Remaining
Length
Remaining Alert
Print Remaining
Length
Select Media
Media Setup
Current Settings
Customize
Settings
RIP Settings
PRODUCT DESCRIPTION
Menu Item/Setting Values (shaded one is the default)
On
Off
5.0 to 99.5 m
1 to 15 m
Print
RIP Settings
1 to 30 (Media Setup Numbers)
1.5
2.0
Platen Gap
2.5
Input thickness.
Manual (Uni-D)
Head Alignment
Manual (Bi-D)
Table 1-15. Setup Menu
Selects [On] to indicate and record the remaining amount of the set media, or
[Off] to set it to off. When [On] is selected, [Length], [Remaining Alert] and
[Print Remaining Length] are displayed to be set. Remaining amount is
derived from the setting values in [Length] and printed media length. It is
displayed on the Control Panel.
Sets the whole length of the set media between 5.0 to 99.5 m. You can make
this setting by 0.5 m.
Sets the value to display the Remaining Alert between 1 to 15 m. You can
make this setting by 0.5 m.
Prints the remaining amount of the media.
Selects the media setting for printing.
When [RIP Settings] is set, the printer prints in the media setting set with
software RIP.
When one of the values between 1 to 30 is selected, the printer prints the
media setting stored in the one of selected number. To store the media setting
in one of the numbers, set it in [Customize Settings].
Changes the current media setting. The items which can be changed depend
on which setting is selected, [RIP Settings] or media number. For the items,
refer to RIP Settings or the row of 1 to 30 as follows.
Changes the Platen Gap (gap between the Print Head and paper surface)
settings in the media setting set with software RIP. Uses [1.5] normally.
Select [2.0] when smudges or blurring appear due to an excess pressure on the
paper. Select [2.5] only when the printed result is not improved even though
set [2.0]. Improper setting may contaminate the inside of the printer with ink,
and it may cause the low print quality or shorten the life of the printer.
Sets the length of the media to be used between 0.1 to 1.0 mm.
When granular images or blurring appear on the printed result, perform Gap
Adjustment to adjust the Print Head misalignment during printing with this
function.
Manual Adjustment: Check the printed adjustment patterns visually and
adjust it by entering the best adjustment values.
Control Panel
Revision A
Explanation
Confidential
21