YASKAWA DI-101 Installation Manual page 14

5 Installation Procedure
2.
Loosen terminals S1 to S8 and SN on the A1000 drive digital Input terminal block
TB1.
Figure 4
Figure 4 Loosen Drive Control Terminals TB1 S1 to S8 and SN
3.
Remove the DI-101 option from the ESD bag.
NOTICE: When handling printed circuit boards (PCB) always use electrostatic discharge (ESD) protection.
Keep the boards in the ESD bag as long as you can. Do not lay the board on any surfaces without the ESD
protection. When handling, always hold the board from the edges and do not touch the components. Before
installing this option, a technically qualified individual, familiar with this type of equipment and the hazards
involved, should read this entire installation guide.
14 YASKAWA TOEP YEAOPT 07 A1000 Option DI-101 120 Vac Interface Installation Manual