Function 5-Modbus Address; Function 6-Set Scan Time - Omega DP606A User Manual

5
Series Navigation
Section 5.11 - Function 5 - Set Modbus Address
The Modbus address is used for serial communications to determine which device
on a bus is being accessed. The current Modbus Address is shown in the Main
Display. The first digit flashes to indicate it can be edited. Use the buttons below to
edit the address.
By Default the Modbus address is 1 and any address from 1 to 247 can be used. The
unit will not allow an invalid address to be displayed. Trying to enter a number
greater than 247 will cause the display to roll back to a valid number.
Section 5.12 - Function 6 - Set Scan Time
The scan time is the time each zone is displayed on the front panel before advancing
to the next zone. By Default, the scan time is 3 seconds. The current scan time is
displayed in the Main Display and the zone display is blank. The left most digit
blinks indicating it can be edited. Use the buttons below to edit the scan time.
13
Function
Increment the flashing digit of the Main display.
Selects the next digit of the Main display, causing it to flash.
Stores the Device address and returns to the Function Select
mode.
Function
Increment the flashing digit of the VALUE display.
Selects the next digit of the VALUE display, causing it to flash.
Stores the current VALUE display as the SCAN time and returns
to the Function Select mode.
ºC
ºF
mA
mV
Zone
ºC
ºF
mA
mV
Zone