Getting Started; Handy Info; Replacing Printer Paper - VeriFone VX 680 User Manual

Getting started

For charger base
• Plug the power supply unit into the lightning bolt port.
• Plug the jug cord into the power outlet and turn on.
Sit the terminal on the powered base and wait a few seconds for it to power on.
For direct connect
• Plug the charging cable directly into the port on the left hand side of the terminal.
• Plug the jug cord into the power outlet and turn on.
Turning your device on/off
• TURN ON THE DEVICE; Hold down the GREEN button on the keypad for 10 seconds.
• TURN OFF THE DEVICE: Hold down the RED button on the keypad for 2 seconds.
• PLEASE NOTE: the terminal cannot be powered off whilst it is sitting on a powered
base or connected directly to power.
Logging on your terminal
• To log on, select the 3 dots ( MENU button ) on screen.
• Select 10. LOGON and press ENTER – a receipt will be printed letting you know if
your logon was successful. If not, please contact our Merchant Help Desk
1800 334 702.

Handy info

• The VX680 runs on the Optus or Telstra GPRS mobile phone network.
• It has an auto turn-off feature, which is pre-set to 15 minutes and designed to maintain battery
life. The timer can be extended but be mindful that leaving the terminal idle for extended periods
will drain the battery.
• Our recommendation is that you perform a manual settlement on the terminal at the completion
of your day's trade. (Note: this must be performed prior to 11:45pm AEST/AEDT).
• Battery strength is indicated on the display allowing you to monitor and re-charge
as necessary.
• When on site, the terminal can be connected to the main power to keep the battery charged.
6

Replacing printer paper

1. Lift tab on back of device and pull cover up.
2. Lay the new receipt roll in the printer with the
paper being fed from the bottom of the roll.
3. Close the printer cover. Ensure the cover clicks
into place and the paper has been thread
through the gap between the cover.
4. Press the 3 Dots on screen (MENU Button) to
bring up the menu. Select 10. LOGON and press
ENTER. If nothing prints on receipt then remove
receipt paper, turn roll over and try again.
7