NCR P1535 Quick Reference Manual

P1535/P1235 Quick Reference
Guide
Graphical Overview
P-Series Stand X-Series Stand
Accessories Included
6ft (2m) Power Cable 90°
Power Connection
The P1535/P1235 has an integrated 19 V, 90 W power supply rated
for 110 V and 240 V (auto-sensing), 50 Hz or 60 Hz located in the
base.
If the power supply is not installed in the base of the P1535/P1235:
a) remove upper stand cover b) loosen thumbscrew that secures the
base cover c) route AC power cord thru base d) install power brick in
base e) secure cables behind CableLock Cover and close all.
a) b)
c) d)
e)
Note: 24V Power Supply is external to base
Wall Mount 1 – Removable SSD
2 – Power Button
3 – Recovery Button
10ft (3m) Network Cable
4 – RJ12 Cash Drawer
5 – HDMI
6 – Display Port
7 – Power In
The NCR Recovery utility can be used to restore
the factory provided image, or make backups. The
default password is "Recovery1234".
To start the recovery process, tilt head back to
expose the I/O panel. The unit must be powered
off before beginning the process.
Press and hold the recovery button. While
holding the recovery button, press the power
buttom to power on the unit. Wait 5 seconds,
and release both buttons.
Power Button and I/O Panel Access
8 – RJ45 Serial Ports (2)
9 – Ethernet Port
10 – USB 3.0
11 – RJ12 Serial Ports (2)
12 – 12V Powered USB
13– RJ12 Serial Port
14 – USB 3.0 (3)
NCR Recovery Utility
Recovery Button
*Press once and release
Expansion Options:
A– 24V Powered USB +
RJ12 Serial Ports (2)
B – 5V USB + RJ12 Serial
Ports (2)
C – RJ45 Serial Port + SIM
+ POE
P-Series stand removal
Lay terminal face down on a flat surface.
Remove the screws (2) that secure the Base Stand to
the display.
Rotate the P-Series Stand and remove the Mounting
Plate Tabs (2) from the openings in the Rear Cover.
497-0478005 Rev A