Charging The Master Station - Aiphone WL-11 Operation Manual

Charging the master station

Charge the master station for 16 hours before using it for the fi rst time.
1
Open the battery cover
Battery cover
2
Connect the connector of the
battery pack to the connector
terminal inside the battery cover
Battery pack
3
Set the battery pack and close the
battery cover
• Do not trap the connector of the battery
pack.
Connector
Red
Black
4
Place the master station on the
charging stand
Status indicator
Use the appropriate plug in your region to
the AC adapter.
• The status indicator switches on red
during charging.
• After suffi cient charging, the status
indicator will be off.
N o t e s
• Charging time increases in the following
conditions.
- The operation temperature is low.
- The AC power voltage is low.
- The master station was used during
charging
- The reception status of this unit is "Out of range"
• Set the master station on the charging
stand when it is not in use. Overcharging
does not occur even when the master
station is always on the stand.
• The status indicator may not switch off
immediately when this unit is removed from
the charging stand.
• The remaining battery power displayed just
after the battery pack is installed may be
lower than the actual value.
• "AIPHONE" is displayed on the screen after
the master station is switched on, and the
status indicator switches on red.
W a r n i n g
• Do not peel off the vinyl cover of the battery pack.
• If this unit will be removed from the charging
stand or the power adapter will be unplugged
for one week or more, remove the connector
and remove the battery pack. (This maintains
the battery pack performance and prevents
consumption of the battery pack.)
22
Installation
Power outlet
Plug
AC adapter
(cable length: approx. 1.8 m)