Using Auto-Check Function -Menu 210 - Sony DSR-1/1P Operating Instructions Manual

Example: 8 minutes
207 08
Blinking
Standby-on period
If the setting does not need to be changed, press
the MENU button to close the menu.
2
Press the SHIFT button until the standby-on period
starts blinking, then press the ADVANCE button.
Each press of the ADVANCE button changes the
setting as follows.
08 (factory setting) n 01 n 03 n 05
3
Press the RESET/(MENU SET) button and then
the MENU button.
The settings are recorded and the display window
returns to the display shown before the VTR menu.
Using Auto-Check
Menu 210
Function
On the DSR-1/1P, the internal check can be
automatically performed using the auto-check
function. Meanwhile, a test recording and playback are
also performed for about 1 minute.
Before shooting, it is desirable to perform auto-check
and make sure for problems in VCR's internal
operations and the VCR/camera connection through
the result of the internal check displayed in the display
window and the video and audio recording qualities.
Preparations for testing
Make preparations as shown in the table below.
Preparation
Connect the DSR-1/1P to the camera
Connect a monitor to the VIDEO OUT or S
VIDEO OUT connector on the DSR-1/1P
Connect an earphone or headphones to the
EARPHONE connector on the DSR-1/1P
Prepare a cassette for test recording/playback Page 35
To perform the auto-check
1
Display menu 210.
2
Press the SHIFT button to make the auto-check
function indication (oFF) start blinking, then press
the ADVANCE button to change the indication to
"on".
To cancel the auto-check function, press the
MENU button to close the menu.
3
Press the RESET/(MENU SET) button.
This changes the display and opens the cassette
holder. If there is a cassette in the holder, it is
ejected (except during recording).
4
Insert the cassette and close the cassette holder.
The display changes to the following, and the tape
is loaded.
5
Use the tape transport buttons to change the tape
position for test recording if necessary, or advance
to step 6.
Refer to
Page 24
Page 15
Page 15
210 oFF
Blinking
Auto-check function
indication
At EJECT n At C-In
Blinking
At rEC
Blinking
Chapter 6 Menu
(Continued)
65