Table of Contents
Advertisement
Package Contents
Ensure that in addition to the V6100, the package contains:
One or two AC power cables.
Four anti-slide bumpers for desktop installation option (supplied in a small plastic bag).
CD (software and documentation).
RS-232 DB9 adapting cable, two meters in length (direct connection to PC).
This V6100 Digital Gateway Installation Guide.
Mounting the V6100
The V6100 can be mounted on a desktop, or installed in a standard 19-inch rack. For
detailed information on cabling the V6100, see
Mounting the V6100 on a Desktop
The integral front brackets are not required for a desktop installation. Optionally, attach the
four (supplied) anti-slide bumpers to the base of the V6100 and place it on the desktop in the
position you require.
Installing the V6100 in a 19-inch Rack
Users can install the V6100 in a standard 19-inch rack either by placing it on a shelf
preinstalled in the rack (preferred method), or by attaching it directly to the rack's frame. If
the rack is without shelves, it is advised to acquire shelves.
Installation of a V6100 in a rack without shelves requires users to directly attach the V6100
integral front brackets and the user-adapted rear brackets (not provided) to the rack's frame.
Users assembling the rear brackets by themselves should note the following:
a) The distance between the screws on each bracket is 28 mm.
b) To attach the brackets, use 4-40 screws with a maximal box penetration
length of 3.5 mm.
To place the V6100 on a 19-inch rack's shelf, follow these 2 steps:
1
Place the V6100 on a preinstalled shelf.
2
It is recommended to attach the V6100 integral front brackets to the frame of the rack to
prevent it from sliding off the shelf during cabling. Use standard 19-inch rack bolts (not
provided) to fasten the front of the V6100 to the frame of the rack.
12
Cabling the
V6100.
V6100 Digital Gateway Installation Guide
Advertisement
Table of Contents
