Omron E5CC Communications Manual page 204

6 Programless Communications
With the default settings, the following parameters are set for the upload areas.
Check the values in the upload areas to see if they are the same as those that are given in
the following table. (It is not necessary to check address for which "---" is given in the Value
column.)
No.0
DM0 DM30
DM1 DM31
DM2 DM32
DM3 DM33
DM4 DM34
DM5 DM35
DM6 DM36
DM7 DM37
DM8 DM38
DM9 DM39
DM10 DM40
DM11 DM41
· · · · · ·
DM13 DM43
DM14 DM44
* If the default settings are used and a sensor is not connected, the PV display on the E5CC will show an input
error (s.err) and the process value in the upload area will be 1320 (528 hex).
 Changing E5CC Settings
(1) We will check the area that is used to change E5CC set values.
The area that is used to change the set value is called the download area.
DM15 to DM29 is the download area for the No. 0 Controller, DM45 to DM59 is the
download area for the No. 1 Controller, and DM75 to DM89 is the download area for the
No. 2 Controller.
6 - 90
No.1 No.2
DM60 Response Flag (fixed)
DM61 Communications Status (fixed)
DM62 Communications Monitor
Parameter
DM63 Status (Upper Word)
DM64 Status (Lower Word)
DM65 Status 2 (Upper Word)
DM66 Decimal Point Monitor
DM67 Process Value
DM68 Internal Set Point
DM69 Heater Current 1 Value Monitor
DM70 MV Monitor (Heating)
DM71 Not used.
· · · · · ·
DM73 Not used.
DM74 Do not use (reserved).
Parameter
0
Alternates between 0 and 1.
---
---
---
---
---
Process Value
---
---
---
---
· · ·
---
---
E5@C Digital Temperature Controllers Communications Manual (H175)
Value
*