General Safety Instructions - Shindaiwa DGK25F Service Manual

2. General Safety Instructions

ELECTRIC SHOCK
NEVER touch the output terminals
during operation
NEVER touch the output terminal during
operation even though the breaker on the
load is being set at "OFF" position.
ALWAYS stop engine and make sure it
stopped before you will connect the loads to
the output terminals.
Suffocation by exhaust gas
NEVER run the engine indoors! Make
sure there is always good ventilation.
Fumes from engine exhaust cause
serious injury.
ALWAYS operate the equipment in the
ventilated area.
When the equipment is used in a tunnel, hall
or any other indoor, the equipment for
ventilation must be used to prevent serious
accident caused by suffocation.
NEVER direct the exhaust fume to
houses nearby while considering the wind
flow direction.
Exhaust gas contains many harmful
elements that would cause affect to human.
Be free from suffocation when the
equipment is used in poorly ventilated area
such as inside of the building.
WARNING
Entangled Injuries under
By Moving Componen
NEVER reach and touch the moving
component during operation!
ALWAYS stop the engine during inspection
to prevent serious bodily injury by entangled
accident under moving component.
Electric shock/Injuries/Burns
Never inspect equipment during
.
use
Never serve and inspect when equipment is
being operated.
It may cause electric shock, injuries or
burns.
WARNING-Use good judgment
NEVER run the engine when transporting
the equipment.
ALWAYS stop the equipment immediately if
it suddenly begins to violate or abnormal
noise. Inspect for broken, missing or
improperly installed parts.
ALWAYS keep the equipment as clean as
practical. Keep it free of loose vegetation,
mud, etc.
DO NOT make unauthorized
modifications or alterations to this equipment
of any of its components. YAMABIKO must
authorize alterations and modifications in
writing. Unauthorized modifications or
alterations may alter the equipment
operation and could jeopardize personal
safety during operation.
2
t