Connecting To Dc Power; Plugs And Pin-Outs - Cisco IR829 Hardware Installation Manual

Connecting the Router
Figure 30: Connecting a Terminal or PC to the Console Port

Connecting to DC Power

WARNING: This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure
that the protective device is rated not greater than 36 VDC, 5A Statement 1005
WARNING: This product requires short-circuit (overcurrent) protection, to be provided as part of the building
installation. Install only in accordance with national and local wiring regulations. Statement 1045

Plugs and Pin-Outs

The IR829 ships with a DC power accessory kit that contains a 4-pin locking connector and pins to use for
the power connections. Four contacts are supplied, but only three are used. One is a spare. The Molex power
connector is Cisco part number 29-2562-01.
The power entry receptacle is on the IR829. The pin-outs are shown in
on page
Figure 31: Power Connector Pin-outs
57.
Cisco IR829 Industrial Integrated Services Router Hardware Installation Guide
Connecting to DC Power
Figure 31: Power Connector Pin-outs,
57