Cisco IR829 Hardware Installation Manual page 65

Industrial integrated services router

Hide thumbs Also See for IR829:

Table of Contents

IP54 Kit Installation

Assembling the IP54 Enclosure

Figure 34: Bottom Cover Assembly

3.. If you have not already done so, attach all cables to their proper connection points on the Cisco IR829 and

route them away from the device. Antenna connections are routed through the guide holes (3).

Note: All cables should be properly routed and lying flat across the entire width of the bottom cover. Avoid

grouping cables together in bundles.

4. Attach the bottom cover (1) to the Cisco IR829 using two short screws (2). Tighten screws until snug.

5. If your device does not have antennas attached, insert the foam plugs into the cable guide holes.

Figure 35: Top Cover Assembly

6. Attach the top cover (5) to the Cisco IR829 using two long screws (6). Tighten screws until snug.

7. Connect the top cover and bottom cover to each other using 2 short screws (7). The screws are routed up

through the guide holes (8) in the lower cover (1) and screwed into the top cover (6). Tighten screws until

snug.

Cisco IR829 Industrial Integrated Services Router Hardware Installation Guide

Table of Contents