Test Run - Grizzly G0513 Owner's Manual

Test Run

Once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
The test run consists of verifying the following: 1)
The motor powers up and runs correctly, and 2)
the safety disabling mechanism works correctly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on Page 60.
If you still cannot remedy a problem, contact our
Tech Support at (570) 546-9663 for assistance.
To test run the machine:
1. Make sure that you have successfully com-
pleted the Initial Blade Tracking procedure
on Page 28 before continuing.
2. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
3. Make sure all tools and objects used during
setup are cleared away from the machine.
4. Connect the machine to the power source.
5. Test the operation of the machine to verify
that it starts and operates correctly.
G0513, G0513ANV & G0513X2 Only
a. Verify that the machine is operating cor-
rectly by pressing the power button.
— When operating
machine runs smoothly with little or
no vibration or rubbing noises.
— Investigate and correct strange or
unusual noises or vibrations before
operating the machine further. Always
disconnect the machine from power
when investigating or correcting
potential problems.
-32-
correctly, the
G0513X2B, G0513X2F, & G0513X2BF Only
a. Insert the key into the power switch (see
Figure 42), then turn it to the "1".
Power Switch
ON Button
OFF Button
Figure 42. G0513X2B and G0513X2BF control
panel.
b. Verify that the machine is operating cor-
rectly by pressing the ON button.
— When operating
machine runs smoothly with little or
no vibration or rubbing noises.
— Investigate and correct strange or
unusual noises or vibrations before
operating the machine further. Always
disconnect the machine from power
when investigating or correcting
potential problems.
c. Press the OFF button to stop the
bandsaw.
d. WITHOUT resetting the OFF button, press
the ON button. The machine should not
start.
— If the machine does start (with the
OFF button pushed in), immediately
disconnect the machine from power.
The OFF button safety feature is not
working correctly. This safety feature
must work properly before proceed-
ing with regular operations. Call Tech
Support for help.
G0513 Series Bandsaws (Mfd. Since 07/18)
correctly, the