DSC PowerSeries Neo LE2080 Installation Manual page 12

2.
Install the Communicator into the panel:
a.
Attach one end of the PC-LINK cable to the panel PCLINK_2 header on the panel (red wire goes on the right-
hand pin of the
b. Insert the assembled communicator into the panel.
NOTE: Ensure that the threaded antenna connection is visible through the knockout hole at the top right of the
panel.
c. Place the nylon washer with bushing (thick flat washer) onto the threaded section of the antenna cable. Insert the
threaded section through the antenna mounting knockout hole at top right of panel.
d. Place the second nylon washer (flat), followed by the brass washer and the brass nut, onto the threaded section
of the cable, outside the panel. Tighten the assembly by hand only (finger tight only- do not over tighten the
antenna assembly).
e. Locate the screw hole on the right side wall of the panel. See Figure 2 "screw". Line up the assembled com-
municator with the right side wall of the panel and, using the screw provided, secure the mounting bracket to the
panel.
f. Attach the other end of the PC-LINK cable to the communicator (red wire goes on the right-hand pin of the com-
municator PC-LINK header (See Figure 3).
g. Using light pressure (finger tight only), attach the supplied white quad band whip antenna to the threaded
antenna connector at top of the panel.
WARNING! - 3G2080(R)E/TL2803G(R)E/LE2080(R)/TL280LE(R) modules are power limited. Do not route any wiring
over the circuit board. Maintain at least 1in. (25.4mm) separation between circuit board and wiring. A minimum of ¼
in. (7mm) separation must be maintained at all points between non-power limited wiring and power limited wiring.
3.
To wire the communicator to the panel, perform the following steps (See
a.
Disconnect both AC power and battery connections from the panel, and disconnect telephone line.
b.
Confirm that the SIM card is inserted in the holder and locked.
4.
Install Network Cable (TL models only). Route the CAT 5 Ethernet cable through back of the panel and plug it into the
communicator's RJ45 jack.
5.
Install the RS-232 connections (R models only). If using the communicator with a 3rd party device, wire the con-
nections as per Table 3.
NOTE: Before leaving the premises the Ethernet communication lines must first be connected to an approved type NID
(acceptable to local authorities). All wiring shall be performed according to the local electrical codes.
panel
PCLINK_2 header (see
Figure 2: HS2016/2016-4/2032/2064/2128 Control Panel
1 2
3
Figure 3
).
Item Description
1 PC-Link Cable Connector
Quad Band Whip Antenna - Use light pressure to
2
attach antenna
3 Screw
Figure 3
12
finger tight
only
):