Advertisement
Note: If you press the on/off button of the Jet
Clean System during the cleaning program, the
program aborts and resets. In this case, the cleaning
stops flashing and the shaver holder returns to its
starting position. The shaver may still be wet and dirty,
because the cleaning program has not been finished.
Note: If you remove the adapter from the wall socket
during the cleaning program, the program aborts. The
shaver holder remains in its current position. When you
put the adapter back into the wall socket, the shaver
holder moves to its highest position.
Note: When the fluid level drops below the minimum
level, the cleaning symbol and the 'fluid low' symbol
start to flash with intervals and the shaver holder
returns to its starting position
Cleaning the Jet Clean system
Empty the cleaning chamber and clean it thoroughly
by rinsing it with hot tap water every 15 days if you
use the Jet Clean System daily. Otherwise empty and
clean the cleaning chamber at least once a month.
1
Clean the outside of the Jet Clean System with
a moist cloth.
Never immerse the Jet Clean System in water, nor
rinse it under the tap.
2
Simultaneously press the release buttons on
both sides of the Jet Clean System (1). Then lift
the Jet Clean System off the cleaning chamber (2).
, The cleaning chamber remains behind.
English
19
Advertisement
