Advertisement
Cleaning the shaving unit in the Jet Clean
system (PT927CC only)
The Jet Clean System cleans the shaving unit.
Preparing the Jet Clean system for use
Note: Fill the cleaning chamber before first use and
when the 'fluid low' symbol flashes to indicate that the
fluid level is too low. When the fluid level drops below
the minimum level, the cleaning symbol and the 'fluid
low' symbol start to flash and the shaver holder returns
to its starting position
1
Simultaneously press the release buttons
on both sides of the cleaning chamber (A).
Then lift the Jet Clean System off the cleaning
chamber (B).
, The cleaning chamber remains behind.
2
Unscrew the cap from the bottle with Jet
Clean solution (HQ200) and remove the
airtight seal.
3
Fill the cleaning chamber with Jet Clean
solution (HQ200) up to the MAX indication.
Note: Make sure the cleaning chamber is always filled
above the MIN indication.
4
Place the Jet Clean System back onto the
cleaning chamber ('click').
Make sure that the release buttons snap back into
place.
When the cleaning chamber is filled with Jet Clean
solution, do not move it to prevent leakage.
English
17
Advertisement
