Care And Maintenance; Cleaning The Printing Head - Roland ColorCAMM PRO PC-600 User Manual

Chapter 3 - User's Reference

3-7 Care and Maintenance

Do not touch the area around the
printing carriage with the hands.
Failure to do so may result in burns.
NOTICE
Be sure to switch off the main power for the PC-600 before attempting to clean the unit and platen or using
head cleaner to clean the printing head.
Never attempt to oil or lubricate the mechanism.

Cleaning the Printing Head

The PC-600 automatically performs cleaning of the printing head.
You can also perform forced cleaning by pressing the [HEAD CLEANING] key, but normally automatic cleaning is sufficient. If printing
is especially grimy, press the [HEAD CLEANING] key to perform cleaning. To start cleaning, hold down the key until a beep is heard.
The head is cleaned with the cleaning pad on the front-left surface of the unit when an ink-ribbon cartridge is replaced. Ordinary grime is
removed by this automatic cleaning, but when soiling is severe, the head cleaner included with the unit should be used to remove it.
The method described below is used to perform cleaning with the head cleaner.
NOTICE
Drops of cleaning fluid may spray out when the cap is opened. Hold away from the platen when opening the
cap. The platen may be discolored by any cleaning fluid that comes in contact with it. (The cleaning fluid is
non-toxic.)
Use the included head cleaner to
remove grime from the edges of the
printing heads.
Edges of the printing heads
If this cleaning fails to remove all grime, then use the included head-cleaning sheet to perform cleaning.
52
Bottom surface of
the printing head
Head cleaner
Separation lever
Be careful not to let any head
cleaner touch the separation lever.