Operation Panel - Roland ColorCAMM PRO PC-600 User Manual

Operation Panel

* "Material setup" refers to the state when material has been loaded and the sheet-loading lever has been lowered.
12) BUSY LED
13) SETUP LED
1) POWER key
2) POWER LED
3) DATA CLEAR key
4) DATA CLEAR LED
5) HEAD
CLEANING key
17) Tool force control slider
1) POWER key
This switches the sub power source on and off.
2) POWER LED
This lights up when the sub power source has been switched
on.
3) DATA CLEAR key
Holding down this key until a beep is heard deletes the data
being received.
4) DATA CLEAR LED
The LED flashes while data is being deleted.
5) HEAD CLEANING key
This performs forced cleaning of the printing heads.
The PC-600 automatically performs cleaning of the printing
heads. There is normally no need to perform forced
cleaning. Press this key to perform cleaning only when
printing is especially grimy.
To start cleaning, hold down the key until a beep is heard.
6) BASE POINT key
Sets the current position of the blade to the base point for
printing or cutting.
This key can be used only after material has been loaded.
Hold down the key until a beep is heard.
7) BASE POINT LED
Setting a base point illuminates this LED.
8) ALIGN POINT key
This sets an align point for correcting the slant of loaded
material.
Hold down the key until a beep is heard.
15) CARTRIDGE HOLDER LED
14) FRONT COVER LED
16) Cursor keys
9) ALIGN POINT LED
Setting a align point illuminates this LED.
10) SHEET CUT key
This separates the printed or cut portion from the roll.
Hold down the key until a beep is heard.
11) CUT TEST key
This performs a cutting test (for verifying that blade force is
correct).
This key can be used only after material setup has been
performed.
12) BUSY LED
This flashes while receiving data and during processing.
13) SETUP LED
This lights up when material setup is finished.
14) FRONT COVER LED
During setup, this flashes when the front cover is opened.
Closing the front cover causes it to remain lit continuously.
15) CARTRIDGE HOLDER LED
This lights up when a ribbon cartridge is installed.
It flashes when the cartridge is installed incorrectly or the
ink ribbon has been used up.
16) Cursor keys
Move the material and carriage.
17) Tool force control slider
This is used to set the blade force.
Chapter 1 - Introduction
6) BASE POINT key
7) BASE POINT LED
8) ALIGN POINT key
9) ALIGN POINT LED
10) SHEET CUT key
11) CUT TEST key
15