Table of Contents
Advertisement
Chapter 2 - Basic Operation
2-9 Cutting Off or Detaching the Material
Do not allow hands or hair to come
near the platen while the carriage is
in motion.
Failure to do so may result in injury due to
sudden movement of the carriage when the
power is switched on/off, when the sheet
loading lever is raised or lowered,
or when the [CUT TEST] key, [SHEET CUT]
key, [DATA CLEAR] key, or [HEAD
CLEANING] key is pressed.
Cutting Off a Piece of Material from a Roll
To cut off a piece of material while leaving the rest of the roll loaded on the machine, you can either press the [SHEET CUT] key, or use
the driver or the machine to set [AUTO SHEET CUT] to [ENABLE], so that the material is cut off automatically.
When separating the material by pressing the
[SHEET CUT] key
To cut off the material at the present location of the knife guide, hold
down the [SHEET CUT] key until you hear a beep.
When sending a material-cutting command
from the computer (driver) to separate the
material automatically
Use the user settings on the PC-600 itself to set [AUTO SHEET CUT] to
[ENABLE]. For more information, see "3-2 Settings (Making Settings on
the PC-600)."
* When the material-cutting command has not been set to "enabled" at
the computer, automatic separation of the material is not performed.
Removing the Material
1
Open the front cover and raise the sheet loading
lever.
36
Canceling
the setup
The carriage
moves to the left.
The material is cut off here
2
Remove the material.
Material
Grit roller
Knife guide
Cut or printed portion
Hide quick links:
Advertisement
Table of Contents
