Table of Contents
Advertisement
Figure 3-7. 19-inch rack mounting brackets for the Stinger MRT 19
Warning
!
cabinet top-heavy or unstable. Take all necessary precautions to anchor the cabinet
securely before installing the unit.
Installing the 19-inch ETSI mounting brackets on the Stinger MRT 19
The 19-inch mounting brackets for the Stinger MRT 19 can be installed to align the
front or mid-point of the chassis with the rails of the 19-inch rack. This is
accomplished by attaching the brackets to the front or mid-point mounting holes of
the chassis as shown in Figure 3-8
To install the mounting brackets onto the unit:
1
Position the brackets to align with the mounting holes at the front or midpoint of
the Stinger MRT 19 chassis.
2
Place a mounting bracket onto one side of the Stinger unit, lining up the two
screw holes on the bracket with two bracket holes on the side of the unit. You
can use bracket holes near the front of the unit or near the midpoint of the unit,
as shown in Figure 3-8.
Stinger® MRT Getting Started Guide
The weight and position of hardware within the cabinet might make the
Installing a Stinger MRT
Identifying and installing mounting brackets
0.984 in.
(25mm)
3-7
Advertisement
Table of Contents
