Table of Contents
Advertisement
Installing a Stinger MRT
Identifying and installing mounting brackets
Figure 3-8. Installing ETSI 19-inch brackets on the MRT 19
3
Using a number 2 Phillips screwdriver, install the 1/4-inch flathead screws
(supplied with the brackets) through the mounting bracket holes into the unit, as
shown in Figure 3-8.
Caution
!
4
Repeat step 1 and step 2 to install the second mounting bracket onto the other
side of the unit.
EIA mounting brackets for the Stinger MRT 19
The Stinger MRT 19 can be mounted horizontally in an EIA rack or enclosure with
mounting rails at least 17.72-inches apart. Mounting points at the front or midpoint
of the Stinger MRT 19 chassis can be used to position the chassis as needed. Use the
supplied screws to attach the brackets to the Stinger MRT 19 chassis.
Figure 3-9. EIA rack mounting brackets for the Stinger MRT 19
Warning
!
cabinet top-heavy or unstable. Take all necessary precautions to anchor the cabinet
securely before installing the unit.
3-8
Failure to use the proper screws might damage the unit.
1.252 in.
(31.8mm)
The weight and position of hardware within the cabinet might make the
Midpoint position
Front position
48 V A
RT N
RT N
48 V B
A
B
LO S
SD
PO R T
2
Stinger® MRT Getting Started Guide
PO R TS
1
PO R T
10
6
5
E
1
ST AT U
S
LO S
G R O U
P
SE L
SD
1
PO R T
Advertisement
Table of Contents
