Chapter 10 Configuring An Oc3-Atm Trunk Module; Installing An Oc3-Atm Trunk Module; Connecting An Oc3-Atm Trunk Module - Lucent Technologies Stinger MRT 19 Getting Started Manual

Configuring an OC3-ATM Trunk
Module

Installing an OC3-ATM trunk module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-1

Connecting an OC3-ATM trunk module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-1

Interpreting OC3-ATM status lights . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-2
Configuring an OC3-ATM trunk module. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-3
Call control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-6
Example of OC3-ATM configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-6
Checking OC3-ATM trunk interface status . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-6
OC3-ATM trunk module specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-13
The OC3-ATM trunk module provides fiber optic interfaces between the Stinger MRT
unit and the carrier ATM core network. The OC3-ATM trunk module provides one or
two 155.52Mbps interfaces for connecting to an ATM switch.
Two versions of the OC3-ATM trunk module are produced. One version is for use in
the Stinger MRT 23, a second version is for use in the Stinger MRT 19 chassis. These
versions are not interchangeable. For product code information about these modules,
see "Stinger MRT models and optional products" on page 1-2.
After installing the OC3-ATM trunk module and connecting it to an ATM switch, you
verify connections by checking the status lights. You then configure the physical link.
Use a status profile to display the state of the OC3 line and any error conditions.
Note The TAOS software addresses the single trunk module slot of the Stinger MRT
as slot 18. This is consistent with number of the second trunk module slot in larger
Stinger models.
Installing an OC3-ATM trunk module
An OC3-ATM trunk module is installed in the same manner as any trunk module.
(For details, see "Installing a trunk module" on page 3-12.) After installation, the
module must be connected and configured according to the instructions in this guide.
Connecting an OC3-ATM trunk module
An OC3-ATM trunk module requires duplex subscriber connector (SC) fiber optic
cable.
Stinger® MRT Getting Started Guide
10
10-1
10-1
10-2
10-3
10-6
10-6
10-6
10-13
10-1