Table of Contents
Advertisement
Configuring T1 and E1 Trunk Modules
Slot-Static-Config profile
Parameter
sparing-change-reason
sparing-change-time
sparing-change-counter
vpi-vci-range
vp-switching-vpi
ima-link-status
ima-link-statistic
send-code-status
pattern-test-status
Slot-Static-Config profile
The setting of the t1e1-trunk-card-mode parameter in the Slot-Static-Config profile
for the T1 or E1 trunk module allows the module to be configured to support either
T1 or E1 lines. This setting and the indication for the module that is displayed with
the show command indicate which type of line is currently supported by the trunk
module.
9-14
Setting
Not used on the Stinger MRT.
Not used on the Stinger MRT.
Not used on the Stinger MRT.
Indicates a virtual path identifier-virtual channel
identifier (VPI-VCI) range.
The system uses the VPI-VCI-Range value to select
the best combination of VPI and VCI bit sizes to fit
the list of supported VPI-VCI pairs obtained from the
network provider.
Indicates the virtual path identifiers (VPIs) that the
system uses for VP switching on the DS1-ATM port.
Subprofile of the DS1-ATM-Stat profile that indicates
read-only status of the IMA link.
Subprofile of the DS1-ATM- Stat profile that
indicates read-only statistics of IMA link.
Indicates the current state of a send code procedure.
Valid values are as follows:
disabled—Send code procedure is currently
disabled on this link.
line-loopback—Line loopback has been
requested to the remote end.
payload-loopback—Payload loopback has been
requested to the remote end.
Indicates the result of a pattern test. Valid values are
as follows:
none—No pattern test has been executed on this
link.
in-sync—Pattern test indicates that the line is
synchronized.
lost-sync—Pattern test indicates that the line
has lost synchronization.
Stinger® MRT Getting Started Guide
Advertisement
Table of Contents
