Lucent Technologies Stinger MRT 19 Getting Started Manual page 51

1 Carefully insert the 50-pin RJ-21 connectors of the subscriber line cables on the
line connectors of the Stinger MRT chassis, as shown in Figure 3-18 on page
3-17.
2 Push the cable connectors onto the chassis connectors until each locking tab is
engaged.
3 Tighten the anchor screw on each cable connector.
4 Secure the cable connectors to the chassis with a cable tie around the connectors
and through the security fixtures on the left side of the line connectors on the
chassis. (Optional, if your cable connectors have a slot to engage the locking tab.)
Figure 3-18. Connecting the subscriber lines to the Stinger MRT 23
-48VA
Stinger® MRT Getting Started Guide
POTS SHELF
BITS ID
MODEM
LINE 1-24
SEE INSTRUCTION MANUAL
SIEHE ANLEITUNG
LIRE LE MANUEL d'INSTRUCTION
USE OF RING LUGS RECOMMENDED
Secure with cable ties
SHELF
-48VB POTS
BITS ID
RTN B
MODEM
LINE 1-24
SEE INSTRUCTION MANUAL
SIEHE ANLEITUNG
LIRE LE MANUEL d'INSTRUCTION
USE OF RING LUGS RECOMMENDED
Connecting cables to a Stinger MRT unit
ETHERNET 10BT EXP1
ALARM RELAY MINOR CONSOLE
MAJOR
LINE 25-48
ETHERNET 10BT EXP1
ALARM RELAY MINOR CONSOLE
LINE 25-48
Tighten anchor screws
Installing a Stinger MRT
EXP2 STATUS GROUP
PORT
1 5
SD
6 10
LOS
SELECT
PORTS
PORT 1
POTS 25-48
EXP2 STATUS GROUP
PORT
1 5
SD
6 10
LOS
PORTS SELECT
PORT 1
POTS 25-48
3-17