Tuning Your Television For The Dvd-Vcr - Samsung V80 Instruction Manual

Tuning Your Television for the DVD-VCR

GB
STANDBY/ON
2
4
16
You must tune your television for the DVD-VCR only if you are not
using a RCA cable
➢
OPEN/CLOSE
1
Switch on the television.
2
Switch on the DVD-VCR by pressing STANDBY/ON on the front of
the DVD-VCR or STANDBY/ON on the remote control.
3
Select a programme position on the television to be reserved for
use with your DVD-VCR.
4
Insert the video cassette in the DVD-VCR. Check that the
DVD-VCR starts reading the cassette; if not, press
5
Start a scan on your television or set the television to UHF
channel 36 (Australia:UHF 38 CH).
6
Fine tune the television until the pictures and sound are obtained
clearly.
7
If you cannot find the pictures and sound, or there is interference
from nearby channels, it may be necessary to change the setting
of the DVD-VCR output channel (see Setting the DVD-VCR
Output Channel on page 25 and Problems and Solutions on page
69).
8
When the picture and sound are perfectly clear, store this channel
at the desired programme position on the television.
Result:
To view pictures from your DVD-VCR when a RCA cable
is used, the television must be set to the audio/video
mode (AV).
That programme is now reserved for use with your
DVD-VCR.
button .
II