Tuning Your Television For The Dvd-Vcr; Deck Control Keys - Samsung CHT-500H Instruction Manual

Tuning Your Television for the DVD-VCR

GB
2
4
14
You must tune your television for the DVD-VCR only if you are
not using a RCA cable
To view pictures from your DVD-VCR when a RCA
cable is used, the television must be set to the
audio/video mode (AV).
1
Switch on the television.
2
Switch on the DVD-VCR by pressing STANDBY/ON on the front
of the DVD-VCR or STANDBY/ON on the remote control.
3
Select a programme position on the television to be reserved for
use with your DVD-VCR.
4 Insert the video cassette in the DVD-VCR. Check that the
DVD-VCR starts reading the cassette; if not, press
5
Start a scan on your television or set the television to UHF
channel 36.
6
Fine tune the television until the pictures and sound are obtained
clearly.
7 If you cannot find the pictures and sound, or there is interference
from nearby channels, it may be necessary to change the setting
of the DVD-VCR output channel (see Setting the DVD-VCR
Output Channel on page 23 and Problems and Solutions on
page 73).
8
When the picture and sound are perfectly clear, store this
channel at the desired programme position on the television.
Result: That programme is now reserved for use with your
DVD-VCR.

Deck Control Keys

The DVD-VCR uses one set of controls to operate both decks.
The following keys are helpful in successfully controlling each
deck.
1
STANDBY/ON Button
Press the STANDBY/ON button on the remote control or front
panel to turn on the DVD-VCR.
2
DVD Button
Press the DVD button on the remote control when you want to
control the DVD deck.
The DVD indicator will light on the Front Panel Display to
show that the DVD deck is selected.
3 VCR Button
Press the VCR button on remote control when you want to
❿ II
button. control the VCR deck.
The VCR indicator will light on the Front Panel Display to
show that VHS deck is selected.
4
INPUT SEL. BUTTON
Press the INPUT SEL. button repeatedly to cycle through all of
your input sources, including the Tuner (PR##), Line (rear AV
input).
• Input select is only available when the VCR deck is selected.
Before using the VCR operation of 19~44 pages, press
the VCR button on the remote control to select VCR
mode.
Before using the DVD operation of 45~65 pages, press
the DVD button on the remote control to select and
watch DVD.
GB
STANDBY/ON PHONES
1
1
4
2
3
15