Using the G-CODE Feature
Before presetting your DVD-VCR:
◆ Switch on both the television and your DVD-VCR
◆ Check that the date and time are correct
◆ Insert the cassette on which the programme is to be
recorded (safety tab intact)
Up to six programmes can be preset.
1
Press the TIMER button.
Result:
The
TIMER METHOD
2
Press the corresponding
is selected.
3
Press the button to select
Result:
A message is displayed to allow you to enter the
G-Code code.
☛
If all six programmes have been set, the message
is Full
is displayed. Refer to page 38 if you wish to
cancel a preset recording.
4
Press the numeric buttons to enter the code opposite the pro
gramme that you wish to record in your television magazine.
➢
If you wish to correct the G-Code code that you are
entering:
◆
Press the
cleared
◆
Enter the correct digit
5
Press the OK button.
Result:
The information concerning the programme is displayed.
☛
When using the G-Code function for the first time with
stored stations, the programme number flashes. This one
time, you must enter the station number manually by
pressing the
◆
The programme number or times flash
◆
You wish to modify the programme
6
If the programme and times are correct, press the RETURN button.
7
Press the STANDBY/ON button to activate the timer.
8
Refer to page 38 if you wish to:
◆
Check that your VCR has been programmed correctly
◆
Cancel a preset recording
☛
The numbers next to each TV programme listing are
G-CODE code numbers, which allow you to programme
your videorecorder instantly with the remote control. Tap
in the G-CODE code for the programme you wish to
record.
™ G-CODE is a trademark of Gemstar Development Corporation. The G-CODE system is
manufactured under licence from Gemstar Development Corporation.
★
(DVD-V80/ DVD-V85 Only)
is displayed.
or
buttons, until the
G-Code
.
button until the digit to be corrected is
or
buttons. Refer to the following page if:
G-Code
option
★
Timer
VCR
OK
1
Timer Method
Standard
G-Code
(DVD-V70)
Timer Method
If you want to set
the timer program,
press the
key.
Code
Code
: 0 - 9
Correct
:
STANDBY/ON
OPEN/CLOSE
7
GB
G-Code
35