Replacing Light Bulbs - Toyota Coaster 2015 Owner's Manual

Replacing light bulbs—

The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the engine switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
To prevent burning yourself, do not
D
replace the light bulbs while they
are hot.
Halogen bulbs have pressurized gas
D
inside and require special handling.
They can burst or
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
z Only use a bulb of the listed type.
z Use bulbs for the 12 V system.
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the
windshield fogs up in the rain. However, if
there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light,
Toyota dealer.
shatter if
Light bulbs
Headlights
For high beam
For low beam
Parking lights
Front turn signal lights
Side turn signal lights
contact your
Rear turn signal lights
Stop/tail lights
Tail lights
Back−up lights
License plate lights
Interior light
Door courtesy light
Step light
A: H7 halogen bulbs
B: Single end bulbs
C: Double end bulbs
D: Wedge base bulbs
W Type
55 A
55 A
5 D
21 B
21 B
21 B
21/5 B
5 D
21 B
5 B
10 B
5 C
5 D
159