Checking the circuit breaker
(glide door)
In the event that the automatic passen-
gers' door does not operate, check the
circuit breaker (C.B.).
To reset the circuit breaker, turn the en-
gine switch to "OFF" and disconnect the
ground cable on the battery. Then careful-
ly insert a thin object, such as a tooth-
pick, needle or safety pin, into the hole in
the circuit breaker until you hear a click.
The automatic passenger's door should
now operate.
If the circuit breaker immediately goes off
again or the automatic passengers' door
does not operate, have the electrical sys-
tem checked by your Toyota dealer as
soon as possible.
158
Adding washer fluid
If the washer does not work, the wash-
er tank may be empty. Add washer
fluid.
You may use plain water as washer fluid.
However, in cold areas where tempera-
tures range below the freezing point, use
washer fluid containing antifreeze. This
product is available at your Toyota dealer
and most auto parts stores. Follow the
manufacturer's directions for how much to
mix with water.
Stopper
Do not use engine antifreeze or any
other substitute because it may dam-
age your vehicle's paint.
NOTICE