Toyota Coaster 2015 Owner's Manual page 116

—Required tools and spare
tire
Jack
Jack handle and
wheel nut wrench handle
1. Get the tool bag, wheel nut wrench
handle, jack, jack handle and spare
tire.
To prepare yourself for an emergency, you
should familiarize yourself with the use of
the jack, each of the tools and their stor-
age locations.
Tool bag
Tighten
(To store)
Wingnut
When removing the jack, loosen the wing-
nut and place the holding plate out of the
way. When storing, place the jack in posi-
tion and secure it by tightening the wing-
nut while holding the plate against the
jack. This will prevent the jack from flying
forward during a collision or sudden brak-
ing.
Loosen
(To remove)
Holding plate
Lower
To remove the spare tire:
1. Insert the end of the jack handle exten-
sion into the lowering screw and turn
it counterclockwise with the handle.
2. After the tire is lowered completely to
the ground, remove the holding brack-
et.
When storing the spare tire, put it in place
with the outer side of the wheel facing up.
Then secure the tire, taking care that the
tire goes straight up without catching on
any other part, to prevent it from flying
forward during a collision or sudden brak-
ing.
109