Table of Contents
Advertisement
Zoom
Determines whether to enlarge/reduce (scaling) the file size so that the file size fits the
output size.
[On] (default)
Turns on scaling.
[Off]
Turns off scaling. Print data is printed at actual size (100%). With this setting, the print data
may not fit on the paper.
Zoom Mode
Determines whether to use A-sizes (A0, A1, A2, A3, A4, and A5) or the effective coordinate
area obtained by the method selected in the area determining mode for auto scaling.
Candidate values are shown below.
[Output Size] (default)
Paper sizes are automatically selected from the six sizes in the A series of paper sizes (A0,
A1, A2, A3, A4, and A5).
[Coordinate Area]
File sizes are determined by the effective coordinate area after the paper margins have
been calculated according to the method selected in [Area Determine].
Note
• If any setting except [Auto] is selected in [File Size], then the [Coordinate Area] cannot be selected.
• [Coordinate Area] setting can only be done if [Auto Layout] is [On]. If it is set to [Off], [Output Size] takes
effect.
Area Determine
Specifies the method of obtaining the effective coordinate area for auto scaling.
Candidate values are shown below.
[Auto] (default)
Select a method to determine the printable area from either IW, IP, Adapted, or PS. The
order of priority is PS > IW > IP > Adapted.
[IW]
The effective coordinate area is set to the area specified by the last IW command in the
data. If there are no IW commands in the data, Adapted determines the effective coordinate
area.
[IP]
The effective coordinate area is set to the area including what is specified by IP commands
in the data. If there are no IP commands in the data, Adapted determines the effective
coordinate area.
[Adapted]
The effective coordinate area is determined by the following conditions.
• Maximum and minimum positions mapped by the commands.
• The largest font size on that page.
• The widest line.
[PS]
The effective coordinate area is set to the area specified by the first PS command in the
data. If there are no PS commands in the data, [Adapted] determines the effective
coordinate area.
2.2 HP-GL Mode Menu Settings
19
Advertisement
Table of Contents
