Fuji Xerox DocuPrint 3105 Settings Manual page 33

When [File Size] Is Set to [Auto] and [Zoom Mode] Is Set to [Output
Size]
The [Hard Clip] setting becomes ineffective. The output size hard clip area is always used.
• When the file size is the same as the paper size, image is actual size (100%).
• When the file size is greater than the paper size, the image is reduced.
• When the file size less than the paper size, image is actual size (100%).
Output Size
File Size
A0
A1
A2
A3
A4
A5
Note
• When origin position is set to layout, the image is drawn with the document laid out at the center.
When origin position is set to bottom left or center, the image is drawn with the origins of the document
and paper aligned.
• Some output sizes may not be used depending on the printer type.
When [File Size] Is Set to [Auto] and [Zoom Mode] Is Set to [Coordinate
Area]
The [Hard Clip] setting becomes ineffective. The extended hard clip area is always used.
The scaling factor is determined by the effective coordinate area and output size.
The following table summarizes effective coordinate areas by paper size.
Note
• Some output sizes may not be used depending on the printer type.
Output
Minimum value
Size
P2x-P1x P2y-P1y
A3 7829
A4 5485
A5 3828
B4 6762
B5 4723
The maximum factor value is 210.0% of the extended hard clip area of each paper size,
while the minimum factor value is 22.5%.
A3
35
50
71
100
100
100
0 degrees
Maximum Value
P2x-P1x P2y-P1y
5485 73075 51200
3828 51200 35733
2648 35733 24720
4723 63120 44088
3297 44088 30773
A4 A5
25 100
35 25
50 35
71 50
100 71
141 100
Minimum value
P2x-P1x P2y-P1y
5485 7829
3828 5485
2648 3828
4723 6762
3297 4723
Unit: %
B4 B5
31 100
43 31
61 43
87 61
100 87
173 100
Unit: plotter units
90 degrees
Maximum Value
P2x-P1x P2y-P1y
51200 73075
35733 51200
44088 35733
44088 63120
30773 44088
3.3 Auto Layout
33