Table of Contents
Advertisement
If entering the value in inches, enter it within -9.8 to 9.8" in increments of 0.1". The default
is [0.0"].
Left & Right
Adjusts the position of the printable area in horizontal direction. The position can be
adjusted within the range of -250 to 250 mm in increments of 1 mm. The default is [0mm].
If entering the value in inches, enter it within -9.8 to 9.8" in increments of 0.1". The default
is [0.0"].
Note
• The part of data that falls outside the printable area will not be printed even if you adjust the position of
the printable area. Also, the part of data that falls outside the printable area due to the adjustment of the
printable area will not be printed.
• Holding down the <
pressing the <
Print Control
HP-GL mode
Switches between graphics language. This setting affects the HP-GL IW, OW, and UC
commands.
Candidate values are shown below.
[HP-GL] (default)
This setting enables the use of HP-GL, HP-GL/2 or HP-RTL. The printer automatically
switches to the applicable language in accordance with the print data that is sent.
[HP-GL/2]
This setting enables the use of HP-GL/2 or HP-RTL.
Hard Clip
Sets the size of the hard clip area.
In the HP-GL mode, the drawing area is limited depending on the paper size. This area is
called the hard clip area, which defines the maximum area for pen movement. This means
that imaging is impossible outside of the hard clip area.
Candidate values are shown below.
[Output Size] (default)
Sets a hard clip area that is the same size as the paper. However, the actual printable area
is maximum printable area of the printer.
[Normal]
The A4, A3, Letter, and Ledger hard clip areas are the same as the Hewlett-Packard
HP7550A.
The hard clip areas of other paper sizes are the same as the printable area of this printer.
Eject Command
Sets either [Enabled] or [Disabled] for the commands (SP, SP0, NR, FR, PG, AF, AH) that
indicate the end of imaging. Receipt of the [Enabled] command specified here terminates
imaging and outputs the paper. The default setting is [Disabled] for all commands except
SP0.
Note
• When multiple commands are specified, imaging is terminated and the paper is output whenever any
one of the specified commands is received.
18
2 Setting the HP-GL Mode
> or <
> button scrolls through the options in a circular fashion. Simultaneously
> and <
> buttons displays the default value.
Advertisement
Table of Contents
