Table of Contents
Advertisement
Quantity
Enter Quantity
Sets the number of copies to be printed.
You can set the number in a range from 1 to 250. The default value is 1.
Note
• The number of copies specified by the client is used when printing. After the printing, the setting on the
control panel will be overwritten to that value. However, when the number of copies was specified from
NetWare or LPD port, the setting on the control panel will not be overwritten after the printing job.
Quantity Setup
Set the method to specify the number of copies to print.
Candidate values are shown below.
[Protocol] (default)
[Stored Prog.]
[Command]
2 Sided Printing
Sets printing on both sides of the paper.
Candidate values are shown below.
[Off] (default)
2 sided printing is not done.
[Long Edge Flip]
Printing is done from left to right.
[Short Edge Flip]
Printing is done from top to bottom.
Note
• 2 sided printing can be set when the duplex unit (optional) is installed.
Rotate by 180
Specify whether to rotate landscape files by 180 degrees before printing.
Candidate values are shown below.
[Disabled] (default)
Disables rotating 180 degrees.
[Enabled]
Rotates 180 degrees before printing.
Bypass- Wait User
Printing is started by operation on the printer (pressing the <OK> button) after printing by
feeding from the bypass tray is instructed.
Candidate values are shown below.
[On]
[Off] (default)
Adjust Position
Moves the hard clip area.
Up & Down
Adjusts the position of the printable area in vertical direction. The position can be adjusted
within the range of -250 to 250 mm in increments of 1 mm. The default is [0mm].
2.2 HP-GL Mode Menu Settings
17
Advertisement
Table of Contents
