Downloading Routes - Mercedes-Benz G-Class Operator's Manual

Features
230
If you select Cancel, the vehicle remote mal-
function diagnosis is canceled completely.
The vehicle operating state check begins.
Meanwhile, the
vated message appears.
When the check is finished, the
cle diagnosis data... (Voice connec‐
tion may be interrupted during data
transfer) message appears. The vehicle data
can now be sent to the Customer Assistance
center.
Press OK to confirm the message.
X
The voice connection with the Customer
Assistance center is terminated.
The Vehicle Diagnosis: Transferring
data... message appears.
The vehicle data is sent to the Customer
Assistance center.
Depending on what the customer service rep-
resentative agreed with you, the voice connec-
tion is re-established after the transfer is com-
plete. If necessary, you will be contacted at a
later time by another means, e.g. by e-mail or
phone.
Further functions of the vehicle remote mal-
function diagnosis include, for example:
transfer of service data to the Customer
R
Assistance center. If a service is overdue, the
COMAND display shows a message about
various special offers at your workshop.
monthly status information e-mail on oil level,
R
air pressure, maintenance, brakes, etc. If
applicable, you will receive information on
special offers in the e-mail.
USA only: this information can also be called
up under "Owners Online" at http://
www.mbusa.com.
Information on the data stored in the vehicle
( page 24).
Y
Information on Roadside Assistance
( page 21).
Y

Downloading routes

Downloading routes allows you to transfer and
save predefined routes in the navigation sys-
tem. To do this, an SD memory card must be
inserted into the COMAND system. If no SD
memory card is inserted, you must insert the
card into the card slot on the COMAND system
before saving.
Vehicle diagnosis acti‐
Sending vehi‐
A route can be prepared and sent either by a
customer service representative or via the
mbrace portal on the Internet. Each route can
include up to 20 way points. When a route has
been received by the navigation system, the
'Route name' has been saved to memory
card. Do you want to start route guid‐
ance? message appears on the COMAND dis-
play. The route is saved to the SD memory card.
To start route guidance: select Yes.
X
An overview of the route is shown in the dis-
play.
i
If you select No, the saved route can be
called up later in the navigation menu.
Select Start.
X
Route guidance is started.
i
Downloaded and saved data can be called
up again in COMAND. Further information can
be found in the "COMAND", "Online and Inter-
net services" and "Download destination/
route" sections.
Speed alert
You can define the upper speed limit, which
must not be exceeded by the vehicle. If this
selected speed is exceeded by the vehicle, a
message will be sent to the Customer Assis-
tance center. The Customer Assistance center
then forwards this information to you. You can
select the way in which you receive this infor-
mation beforehand. Possible options include
text message, e-mail or an automated call.
The data which is sent to the Customer Assis-
tance center contains the following information:
the location where the speed limit was excee-
R
ded
the time at which the speed limit was excee-
R
ded
the selected speed limit which was exceeded
R
Geo fencing
Geo fencing allows you to select areas which the
vehicle should not enter or leave. You will be
informed if the vehicle crosses the boundaries
of the selected areas. You can select the way in
which you receive this information beforehand.
Possible options include text message, e-mail or
an automated call.
The area can be determined as either a circle or
a polygon with a maximum of ten corners. You