Mercedes-Benz G-Class Operator's Manual page 234

Features
232
Integrated remote control in the rear-view mirror
Indicator lamp
:
Transmitter buttons
; = ?
A Garage door remote control
Transmitter button on the garage
B
door remote control
Garage door remote control A is not part of the
garage door opener.
i
To achieve the best result, insert new bat-
teries in garage door remote control A of
your garage door drive before programming.
Delete the memory of the integrated remote
X
control ( page 234) before programming it
Y
for the first time.
Turn the SmartKey to position 2 in the ignition
X
lock ( page 112).
Y
Press and hold transmitter button ;, =
X
or ?.
After a short time, indicator lamp : will start
flashing. It flashes approximately once per
second.
i
Indicator lamp : flashes immediately the
first time that the transmitter button is pro-
grammed. If this transmitter button has
already been programmed, indicator lamp :
will only start flashing at a rate of once a sec-
ond after 20 seconds have elapsed.
Continue to hold the transmitter button.
X
Point transmitter button B of garage door
X
remote control A towards the transmitter
buttons on the rear-view mirror at a distance
of 2 to 12 inches (5 to 30 cm).
i
The distance between garage door remote
control A and the integrated garage door
opener depends on the system of the garage
door drive. Several attempts might be neces-
sary. You should test every position for at
least 20 seconds before trying another posi-
tion.
Keep transmitter button B on garage door
X
remote control A pressed until indicator
lamp : starts to flash rapidly.
The programming has been successful if indi-
cator lamp : flashes rapidly.
Release transmitter buttons ;, = or ? on
X
the integrated remote control and transmitter
button B on the garage door remote control.
If indicator lamp : goes out after approx-
imately 20 seconds and has not flashed rapidly:
Release transmitter buttons ;, = or ? on
X
the integrated remote control and transmitter
button B on the garage door remote control.
Repeat the procedure for the other transmit-
X
ter buttons. When doing so, vary the distance
between the garage door's remote control
and the transmitter buttons in the rear-view
mirror.
i
If the garage door system works with a roll-
ing code, you must synchronize the remote
control integrated in the rear-view mirror with
the garage door system receiver after pro-
gramming.
You will find further information in the garage
door opening system's operating instruc-
tions, e.g. the sections on "Synchronizing the
transmitter" or "Registering a new transmit-
ter". You can also call the hotline mentioned
above.
Synchronizing the rolling code
Integrated remote control in the rear-view mirror
Indicator lamp
:
; = ? Transmitter buttons
A Garage door remote control
Transmitter button on the garage
B
door remote control
Your vehicle must be within reach of the garage
door or gate opener drive. Make sure that nei-