Chapter 4 Set Up the ETERNUS DX/AF Storage System for BS2000
4.2 Configuring Settings for the Fibre Channel Ports (CA Parameters)
TPGS Mode
Sense Data Conversion
4.2
Configuring Settings for the Fibre Channel Ports
(CA Parameters)
Please be aware that only a homogeneous sharing with other BS2000 Servers is supported for FC Ports which
are connected to a BS2000 server. The combine Port Mode CA/RA is not supported by ETERNUS DX S2, but
tolerated as of ETERNUS DX S4/S3 and ETERNUS AF.
Note: In these terms the Management Unit (MU) and the Server Unit (SU x86) of an SE Server, resp. the
Server Unit of an SQ-Server are considered to be a BS2000 server, irrespective of whether Linux/Windows
guests are running or not on the Server Unit. The Application Unit of an SE Server /SQ-Server is a non-BS2000
server.
When setting a Fabric connection, complete the preparation work and set up the Fibre Channel switch
beforehand.
For further details, refer to "ETERNUS DX/AF Storage Systems Server Connection Guide (Fibre Channel) Fibre
Channel Switch Settings Administrator's Guide".
Controller
DX/AF series
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection-
Parameter
Connectivity > Port Group > FC
15
Copyright 2018 FUJITSU LIMITED
BS2000
Enable (Default)
No Conversion (Default)
Category
Action
Configure FC Port
P3AM-5672-10ENZ0