Registering The Wwns Of The Accessing Fibre Channel Cards - Fujitsu ETERNUS DX S2, ETERNUS DX S3, ETERNUS DX S4, ETERNUS AF Configuration Manual

Chapter 4 Set Up the ETERNUS DX/AF Storage System for BS2000

4.3 Registering the WWNs of the Accessing Fibre Channel Cards

4.3 Registering the WWNs of the Accessing Fibre Channel Cards
Register the WWN of each Fibre Channel card installed on the server that will access the ETERNUS DX/AF
storage system. At the same time, set the host response numbers registered in
Responses" (page 14)
WWN registration combined with the host affinity settings (described later) limits which server has access to
which ETERNUS DX/AF storage system LUNs.
When a server-side Fibre Channel is replaced (SQ-Server or SE Server (SU x86)), the WWN of the replacement
Fibre Channel card must be re-registered to the ETERNUS DX/AF storage system.
Controller
DX/AF series
SE Server (SU /390) and S-Server:
We recommend assigning a name which identifies the host and the FC channel (e.g. FC channel 8C on the
host S210 -> Name "S210-8C").
SE Server (SU x86) and SQ-Server:
We recommend assigning a name which identifies the host and the slot and port number of the FC channel
(e.g. FC channel in slot 2 port 0 on the host host1 -> Name "host1-2-0").
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection-
to accept these WWNs.
Connectivity > Host Group > FC/FCoE
17
Copyright 2018 FUJITSU LIMITED
Category
"4.1 Setting the Host
Action
Add FC/FCoE Host
P3AM-5672-10ENZ0